another question about F.A.L.

[Bob Flowers]

how do you get the trigger pin and hammer pin out of the lower reciever?
I tried tapping them and they won't come out . I don't want to flare or damage them .
Bob

[Knimrod]

Remove the hammer spring cylinder and the selector. Locate the locking plate on inside surface of the of the lower receiver and rotate it up and out. The locking plate keeps the the hammer and trigger/sear pin from coming out. With the locking plate removed, the hammer pin should come right out. Be careful when removing the trigger/sear pin. There are many small parts and springs that will come out and be hard to find after they've bounced off a few walls. Also be mindful of which springs go where. Some look the same but are not interchangeable.

If you PM me an email address, I can email you a schematic that might help a bit.

[Knimrod]

(moved to DIY gunsmithing)

[Bob Flowers]

THANKS AGAIN