golwise
05-17-2015, 11:08 PM
I purchased a Sako Finnwolf a few years ago and am now just getting around to scoping it. When I bought the rifle, it had rings attached but no scope. I didn't pay much attention to the rings except that they were attached to tapered bases and the bases were attached to the receiver.
Now, when I look closer I see that each ring has two tightening screws on the left side but none on the right side; the rings are not split. How do I get a scope into these rings? I once had an old Lyman Alaskan (7/8" tube) which came with none removable non-split rings and was told that it came from Lyman that way. Well, these rings do not have a scope in them, and I want one in them! Any ideas?
Good Old Lenny
Now, when I look closer I see that each ring has two tightening screws on the left side but none on the right side; the rings are not split. How do I get a scope into these rings? I once had an old Lyman Alaskan (7/8" tube) which came with none removable non-split rings and was told that it came from Lyman that way. Well, these rings do not have a scope in them, and I want one in them! Any ideas?
Good Old Lenny