Can you guys open these?
Last edited by Moleman-; 01-13-2018 at 07:06 PM.
Life Member, NRA, Lapeer County Sportsmen's Club Disclaimer: I Am Not A Lawyer. Opinions expressed are not representative of any organization to which I may belong, and are solely mine. Any natural person or legal entity reading this post accepts all responsibility for any actions undertaken by that person or entity, based upon what they perceived was contained in this post, and shall hold harmless this poster, his antecedents, and descendants, in perpetuity.
testing via IT expert. Can you see it now?
Last edited by Moleman-; 01-12-2018 at 02:05 PM.
Life Member, NRA, Lapeer County Sportsmen's Club Disclaimer: I Am Not A Lawyer. Opinions expressed are not representative of any organization to which I may belong, and are solely mine. Any natural person or legal entity reading this post accepts all responsibility for any actions undertaken by that person or entity, based upon what they perceived was contained in this post, and shall hold harmless this poster, his antecedents, and descendants, in perpetuity.
Thanks for being helping Roundballer, they all show up for me which is hard to figure out the issue. The two that didn't show but now do, all I did is erase it and put it back for the 3rd time. Just got done with the rest of them so hopefully they all took.
Thanks, they show up fine for me so unless someone tells me I think they're there. It was just the first 357AR rifle upper I'd made from extra parts I had laying around and one of the $30 timberwolf barrel blanks that were floating around 5-10 years ago. It worked so I trashed that barrel and got a decent .358 1:14" GMB blank from all the ones from there on out.
I've been hooked on the Max for a long time and remember a gun smith by the name of Dave White that used a .22 cal case from over seas to blow out into a extra long Max case with which he picked up a few more FPS. With the Max case you kinda run out of room fast if you use Acc 1680 because of having to compress the powder and when I heard that Starline was offering .223 basic cases I called and asked if .357 Max cases could also be produced. If Starline would produce .357 Max basic cases at 1.7 inches you could clean up the TC forcing cone mess, With what your doing with the .357 AR it can only help to get more attention for the .358 bore.