Q11 and Q15 look right if I see the webpage properly
Q11 and Q15 look right if I see the webpage properly
this shape ?
Frankly I do not subscribe to the theory of polishing feed ramps, but that by itself is another discussion.. The SIG P6 barrel ramp is designed for ball ammo. When I had my P6 about 5 years ago I couldn't shoot hollow points with it. I had to send it to Customized creationz for a re machined ramp. Todd was an expert in the required dimensions for the new ramp and he did machine the ramp to te new dimensions and the polish it to smoothen the cut surface. I could shoot anything with that gun.
The point is if your P6 barrel is stock from the 1978 era, it has the ball ammo ramp design. The issue might have arise with the new ammo that you are shooting that it might have a profile that is not as friendly with the feed ramp geometry that is already known to be finicky and only made for ball ammo. Polishing will not solve the problem, and re ramping the barrel takes alot of technical skill. Give Todd a call and see if he still does re ramping work on P6 barrels.. Pay the fee and avoid the risk of damaging your barrel.
The rounded bullet point shape
All ramps should be smooth. Many mass produced guns including higher end ones have machining marks perpendicular to the feed axis.
These can cause visible copper build-up over time on the ramp, a sure sign of excess friction and an impediment to smooth reliable feeding.
All we are doing here is removing high spots [ridges] to give a smooth ramp surface. Should be done at factory but secondary finishing operations cost a lot and are frequently eliminated.
Altering ramp profile is another issue entirely but that is gonna take you a long long time using a felt bob with rouge or a fine cratex point. Unless you are using an abrasive grinding point you will burn out your Dremel before you remove enough metal to change the shape that much.
I had not thought of that. Is this something you heard them doing before ?
The crappy part is the barrels have sorta dried up for the p225/p6.
I guess I could just shoot power r ball hollow points. I think since I polished it even half ass i think practice ammo will be fine.
I really would like a barrel though that is not as much as I paid for the entire gun surplus. This is way more complicated than I thought when I bought this p6