Re-assembling my upper and lower after cerokoting. Running into two issues.
1. The BCG is rubbing against the hook in the picture. 1st picture attached. Any ideas on what is causing this?
https://photos.google.com/share/AF1Q...ZKY0NYckJOV0Rn
2. The LRHO latch has a small piece under the LRHO release. When I push the roll pin in place this part binds up and stops moving. I assume it should float free is that correct? Should I use a small jewlers file and open it up untill it moves freely? Picture attached of the part in question.
https://lh3.googleusercontent.com/DY...w1415-h1885-no
Thanks
Jeremy