Looking for a rear sight for a shotgun that is plastic and glues onto the barrel.
Does anyone know of one?
I've had them on single shot turkey guns for 37 years. Snapped one off today.
I really don't want to drill and tap.
Looking for a rear sight for a shotgun that is plastic and glues onto the barrel.
Does anyone know of one?
I've had them on single shot turkey guns for 37 years. Snapped one off today.
I really don't want to drill and tap.
"But then there are plenty of gun folks who think no one should rock the boat because it might piss off the anti gun crowd/politicians and cause even more gun control." - Bikenut
Submissive gun rights advocates need to lose their submissiveness before we lose our 2A rights.
I know scatergun tech aka Wilson makes ghost rings affixed with high temp epoxy.
Last edited by dirtmcgirt76239; 10-12-2018 at 07:06 PM.
Williams and a few other companies make clamp on sights that attach to your vent rib if you have one on your barrel.
"Saepe errans, numquam dubitans --Frequently in error, never in doubt".
The trouble with the Internet is that it's replacing masturbation as a leisure activity. ~Patrick Murray
I think you could use a Williams WGRS-37, depending on your barrel diameter. It fits Ithaca, BPS and Mossberg shotguns.
Get the surfaces clean and attach with Loctite Black Max or JB Weld.
or mount these the same way, much cheaper.
https://www.ebay.com/itm/Williams-t-....c100276.m3476
Wrap emery cloth on barrel and sand to proper contour.
Last edited by john.41; 10-17-2018 at 08:18 PM.